| A monogrammed swim cap is an accessory that can be personalized with initials to represent the wearer’s name. This article will take you through several steps of monogramming a swim cap to customize your own monogrammed one! 1) Steps to Customize Your Cap Let’s monogram step one! First, pick a location for your monogram. This is the first letter of the wearer’s name and can sit on either side or above their hairline (the back third of the cap). Then make sure to iron on heat vinyl pieces onto each section you want to be monogrammed. Iron-on vinyl pieces to desired sections and then move onto step two! Step two is simply choosing which letters you need to create your design. Monograms are typically three initials long but can be one letter if that’s what best fits with your personalized caps. Each piece will come cut out individually, so make sure they are all facing the right direction before moving to the next step! Once this has been completed, take an Exacto knife to cut out the monogrammed swim cap. Step three is taking your monogram pieces and applying them to your new monogrammed hats! This can be done with fabric glue or heat transfer vinyl adhesive spray glue; however, I would recommend something that will withstand water, so you don’t have any issues in the pool. Once this has been completed, take a piece of ribbon (at least two inches longer than the desired length) and thread it through one side hole on top of monogrammed best swimming cap Optional: Add ties by cutting four small elastic strips for each tie holder at about an inch long each – Sew these onto either end using tiny stitches close together, knotting off once complete. Steps include monogramming the band with heat vinyl cutter or fabric glue caps! This can be done with fabric glue or heat transfer vinyl adhesive spray glue; however, I would recommend something that will withstand water, so you don’t have any issues in the pool. Once this has been completed, take a piece of ribbon (at least two inches longer than the desired length) and thread it through one side hole onto a cap. 2) How much can this process cost? This can cost anywhere from $150 to $700 3) Is it easy to do by myself? This can be monogrammed by yourself, but you will need to make sure that your stitches are small and close together. You will also want to use a thread that is not too thick as it may cause the fabric glue or heat transfer vinyl adhesive spray glue not to adhere correctly. This monogramming process only takes about 20 minutes once completed with both hands at work (you don’t want any mistakes). I like how simple this monogramming project was because of its positive results! It looks great on my pool bag and even better in the water. We hope this information has been helpful to you. |
No Comments